The Ingenico Move 5000 contains a Li-ion battery and can be operated without being permanently connected to power. If the battery level is low, it must be connected to power and recharged.
Charging your device
Connect the supplied terminal power supply unit to the charging port on the left side of the terminal. A charging icon will be displayed on the on-screen status bar when the device is connected to power.
Turning device on/off
| Turn on | Press and hold the green button on the keypad for at least 2 seconds to turn on the device. The power up process will take approximately 1 minute to complete. |
| Restart | Press the button on the keypad, then select "Restart". |
| Turn off | Press the button on the keypad, then select "Shutdown". |
Replacing the battery
- Remove the back cover by sliding the switch upwards.
- Lift the panel upward and firmly pull it away from the terminal.
- Place the new battery in the allotted slot.
- Pull down the panel on the battery to lock it in place.
- Replace the back cover and slide the switch down to its original position.
